Toyota T100 1996 Service Manual page 1308

MT−28
MANUAL TRANSMISSION (R150, R150F)
1996 TOYOTA T100 (RM449U)
Z03554
A B C
Z03555
Z03556
WM0064
− OUTPUT SHAFT
INSPECTION
1. INSPECT OUTPUT SHAFT
(a) Using a micrometer, measure the output shaft flange
thickness.
Minimum thickness: 4.70 mm (0.1850 in.)
If the thickness is less than the minimum, replace the output
shaft.
(b) Using a micrometer, measure the outer diameter of the
output shaft journal.
Minimum diameter:
A 1st gear: 38.860 mm (1.5299 in.)
B 2nd gear: 46.860 mm (1.8449 in.)
C 3rd gear: 37.860 mm (1.4905 in.)
If the outer diameter is less than the minimum, replace the out-
put shaft.
(c) Using a dial indicator, check the shaft runout.
Maximum runout: 0.06 mm (0.0024 in.)
If the runout exceeds the maximum, replace the output shaft.
2. INSPECT 1ST AND 3RD GEARS SYNCHRONIZER
RING
(a) Check for wear or damage.
(b) Check the braking effect of the synchronizer ring.
Turn the synchronizer ring in one direction while pushing
it to the gear cone. Check that the ring locks.
If the braking effect is insufficient, apply a small amount of the
fine lapping compound between the synchronizer ring and gear
cone. Lightly rub the synchronizer ring and gear cone together.
NOTICE:
Ensure the fine lapping compound is completely washed
off after rubbing.
(c) Check again the braking effect of the synchronizer ring.
MT04Y−05