Toyota T100 1996 Service Manual page 1404

AT−36
1996 TOYOTA T100 (RM449U)
AUTOMATIC TRANSMISSION
21.
Remove the 2 bolts and starter.
Q06801
22.
Remove the 8 bolts, LH, RH stiffener plates and rear end plate.
23.
24.
Q06802
25.
(a)
(b)
26.
Remove the 8 bolts and support member.
Q06881
27.
(a)
(b)
Q02647
(c)
Q06804
− AUTOMATIC TRANSMISSION UNIT (A340F)
REMOVE STARTER
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
REMOVE STIFFENER PLATE AND REAR END PLATE
Torque: 37 N·m (380 kgf·cm, 27 ft·lbf)
REMOVE FRONT STABILIZER BAR (See page
SA−127)
JACK UP TRANSMISSION
DISCONNECT REAR MOUNTING INSULATOR
Remove the 2 bolts and dynamic damper.
Torque: 61 N·m (620 kgf·cm, 44 ft·lbf)
Remove the 4 bolts and rear mounting bracket.
Torque: 18 N·m (180 kgf·cm, 13 ft·lbf)
REMOVE REAR SUPPORT MEMBER
Torque: 95 N·m (970 kgf·cm, 70 ft·lbf)
REMOVE TRANSMISSION
Turn the crankshaft to gain access to each bolt, remove
the 6 bolts with holding the crankshaft pully bolt with a
wrench.
Torque: 41 N·m (420 kgf·cm, 30 ft·lbf)
Disconnect the wire harness and connectors from the
transmission.
Remove the 6 bolts and transmission.
Torque: 71 N·m (730 kgf·cm, 53 ft·lbf)