Sharp MX-FXX1 Service Manual page 63

SW Bit
Item
No. No.
155 1-6 Not used
7 Selection of the
Internet FAX date and
transmission source
print language
<format>
8 Report output (when
reception is refused)
<Internet FAX only>
156 1 Display setting at times
of NW trouble
2 Job log memory at
times of successive
communication
3 Valid/Invalid setting of
Internet FAX A4, 8.5 x
11 threshold
4-7 Not used
8 Setting of mail
reception method
157 1-5 Not used
6 Setting of transmitted
data upper limit value
(FTP/desktop/shared
folder)
7-8 Transmitted data upper
limit (FTP/desktop/
shared folder)
158 1-8 Not used
SW selection and function
Setting to determine the format of the date and transmission source
attached when transmitting Internet FAX.
"0": Date format
"1": North American format
Setting to determine whether or not to output the communication results
sheet when reception is refused in Internet FAX reception. However,
other than not printing is set by means of the report output (when
receiving Internet FAX) setting.
"0": Do not output
"1": Output
FAX is set at "Report output (when reception is refused) <FAX only>."
Irrespective of "Always print" and "Error," the results sheet is not
printed.
Setting to determine whether or not to display on the operation panel
when network trouble occurs while the NIC card is loaded.
"0": Display trouble
"1": Do not display trouble (do not display "CE-00" and "CE-01")
Setting to determine whether successive communications in the job log
are treated as 1 communication at a time or as 1 successive
communication.
"0": Treat as 1 successive communication
"1": Treat each communication as 1
When printing received Internet FAX data with A4 and 8.5 x 11 paper in
the tray, this setting determines whether to make threshold values in
paper selection valid or invalid.
"0": Valid
"1": Invalid
Setting of FAX received data is performed by means of a separate SW.
Setting to determine whether to receive mail in the mail server as SMTP
or POP3.
"0": POP3
"1": SMTP
When transmitting to FTP, desktop or a shared folder, this setting
determines whether or not to stop transmission of data as over the
upper limit if the image data size of 1 job is found to be in excess of the
value set for the "transmitted data upper limit (FTP/desktop/shared
folder)."
"0": OFF
"1": ON
This sets the upper limit for image data size in 1 job in cases where the
transmitted data upper limit (FTP/desktop/shared folder) is set at "ON."
"00": 50Mbyte
"01": 150Mbyte
"10": 300Mbyte
The initial value is reverted to if a value outside of the setting range is
set.
MX-FXX1 SIMULATIONS, FAX SOFTWARE SWITCH 5 – 54
Initial value
1
1
0
0
1
0
0 Date format
0 Do not output
0 Display trouble
0 Treat each communication
as 1
1 Invalid
0
0
1
0
0 POP3
0
0
0
0
0
0 OFF
0 150MByte
1
0
0
0
0
0
0
1
0
System
settings