Sharp MX-FXX1 Service Manual page 25

66-29
Purpose : Clear
Function (Purpose) : Used to initialize the telephone book data
(the one-touch registration table, the FTP/
Desktop expansion table, the group expan-
sion table, the program registration table,
the interface memory box table, the meta
data, InboundRouting, and the Documen-
tAdmin table).
Section : FAX
Item : Data (Initializing)
Operation/Procedure
1) Press [EXECUTE] button.
[EXECUTE] button is highlighted and [YES] and [NO] buttons
become active.
2) Press [YES] button.
The telephone book data area cleared. [YES] button is high-
lighted.
* When [NO] button is pressed, [EXECUTE] button returns to
the normal display and [YES] and [NO] buttons gray out.
* During the telephone book data clear, [EXECUTE] and
[YES] buttons are highlighted.
3) After completion of memory clear, [EXECUTE] button returns
to the normal display and [YES] and [NO] buttons gray out.
66-30
Purpose : Operation test/Check
Function (Purpose) : Used to display the TEL/LIU status change,
The display is highlighted by status change.
Section : FAX
Item : Operation
Operation/Procedure
1) When the machine enters Simulation 66-30, the following
screen is displayed.
2) HS1, HS2, RHS, and EXHS are highlighted when the signal is
detected, and displayed normally when the signal is not
detected.
<TEL/LIU status change item description>
HS1 Polarity inversion signal
HS2 Polarity inversion signal
RHS Handset hook SW
EXHS External telephone hook SW
SIMULATION NO.66-30
TEST
TEL/LIU SENSOR CHECK
HS1 HS2
CLOSE
RHS EXHS
MX-FXX1 SIMULATIONS, FAX SOFTWARE SWITCH 5 – 16
66-31
Purpose : Setting
Function (Purpose) : Used to set ON/OFF the port for output to
TEL/LIU.
Section : FAX
Item : Operation
Operation/Procedure
1) When the machine enters Simulation 66-31, the following
screen is displayed.
* When starting execution of the simulation, the current set-
ting is displayed.
2) Change the port setting.
When a port is set to ON, the port display is highlighted. Two or
more ports can be selected.
* At that time, the actual port output is not reflected.
3) When [EXECUTE] button is pressed, the changed setting is
reflected to the port which outputs to TEL/LIU.
4) To terminate the process, press [EXECUTE] button again.
[EXECUTE] button returns to the normal display.
<Port which outputs to TEL/LIU>
CION MR
SIMULATION NO.66-31
TEST
TEL/LIU SETTING.
CION MR
66-32
Purpose : Operation test/Check
Function (Purpose) : Used to check the fixed data received from
the line and to display the result.
Section : FAX
Item : Operation
Operation/Procedure
1) Press [EXECUTE] button to check the fixed data received from
the line. At that time, [EXECUTE] button is highlighted.
* Fixed data check procedure
• The data received from the line is checked of the following
fixed data status for minutes, then if they are in accord with
"OK" is displayed on LCD, if not "NG" is displayed.
• The judgment is made in 2 minutes.
Receive speed: 300BPS
Receive data: 00H
Judgment data: 100byte
2) After completion of check, [EXECUTE] button returns to the
normal display. The result is displayed as "OK" or "NG."
* To check the fixed data again, press [EXECUTE] button, and
check of the fixed data can be made again.
SIMULATION NO.66-32
TEST
RECEIVED DATA CHECK
CHECKING
EC S.
CLOSE
EC S.
EXECUTE
CLOSE
EXECUTE