Sharp MX-FXX1 Service Manual page 23

SIMULATION NO.66-18
TEST
DTMF SIGNAL OUTPUT.(SOFT SW)
2
1
4
5
8
7
0
66-19
Purpose : Backup
Function (Purpose) : Used to write the telephone book data
stored in HD into the FLASH ROM.
Section : FAX
Item : Data
Operation/Procedure
1) Press [EXECUTE] button.
[EXECUTE] button is highlighted and [YES] and [NO] buttons
become active.
2) Press [YES] button.
The telephone book data stored in HD are written into the
FLASH ROM. [YES] button is highlighted.
* When [NO] button is pressed, [EXECUTE] button returns to
the normal display and [YES] and [NO] buttons gray out.
* During execution of backup, [EXECUTE] and [YES] buttons
are highlighted.
3) After completion of memory writing, [EXECUTE] button returns
to the normal display and [YES] and [NO] buttons gray out.
SIMULATION NO.66-19
TEST
ADDRESS DATA BACK UP. (WRITE TO FLASH ROM)
YES
ARE YOU SURE?
66-20
Purpose : Backup
Function (Purpose) : Used to write the telephone book data
stored in the FLASH ROM into HD.
Section : FAX
Item : Data
Operation/Procedure
1) Press [EXECUTE] button.
[EXECUTE] button is highlighted and [YES] and [NO] buttons
become active.
2) Press [YES] button.
The telephone book data stored in the FLASH ROM are writ-
ten into HD. [YES] button is highlighted.
* When [NO] button is pressed, [EXECUTE] button returns to
the normal display and [YES] and [NO] buttons gray out.
* During execution of read/write, [EXECUTE] and [YES] but-
tons are highlighted.
3) After completion of memory writing, [EXECUTE] button returns
to the normal display and [YES] and [NO] buttons gray out.
3
6
9
#
EXECUTE
CLOSE
NO
EXECUTE
MX-FXX1 SIMULATIONS, FAX SOFTWARE SWITCH 5 – 14
SIMULATION NO.66-20
TEST
ADDRESS DATA BACK UP. (READ FROM FLASH ROM)
YES
ARE YOU SURE?
66-21
Purpose : Check
Function (Purpose) : Used to print the selected items (various
registration
management information, file management
information, system error, protocol moni-
tor).
Section : FAX
Item : Data
Operation/Procedure
1) When an item button to be printed is selected, it is highlighted
and the previously set button returns to the normal display.
(Default select: Left upper)
* Only one item can be selected.
2) Press [EXECUTE] button.
[EXECUTE] button is highlighted and printing is started.
* During printing an item, [EXECUTE] and the print item but-
ton are highlighted.
3) After completion of printing, [EXECUTE] button returns to the
normal display.
* When [C], [CA], [SYSTEM SETTINGS], or [EXECUTE] key is
pressed during printing, the operation is interrupted.
<FAX information print content table>
REGISTERED MANAGEMENT
FILE MANAGEMENT SYSTEM ERROR LINE 1
PROTOCOL LINE 1
SIMULATION NO.66-21
TEST
FAX INFORMATION PRINT OUT.
REGISTERED
FILE MANAGEMENT
PROTOCOL LINE 1
66-22
Purpose : Setting
Function (Purpose) : Used to set the handset sound volume.
(This simulation can be executed even
though the handset setting is set to NO.
When,
installed, the sound volume cannot be
checked.) (Japan model only)
Section : FAX
Item : Operation
Operation/Procedure
1) When the machine enters the simulation, the number of the set
sound volume is displayed. (In this example, MIDDLE is set as
the default sound volume.)
CLOSE
NO
EXECUTE
information, communication
MANAGEMENT
SYSTEM ERROR LINE 1
EXECUTE
however, the handset is not