Sharp MX-FXX1 Service Manual page 43

SW Bit
Item
No. No.
48 1-4 V.34 Symbol Rate
Mask (when receiving)
5-8 Not used
49 1-5 Not used
6 PIN code
correspondence
7-8 Dial call waiting time
50 1-7 Not used
8 Dial tone ON detection
time (during
continuous detection)
51 1-4 Time for prohibition of
waiting at both speeds
after sending CFR/
MCF
5-6 Not used
7-8 V.8 mode ANSam
signal sending time
SW selection and function
This sets the symbol rate when receiving in the V.34 mode.
"0000": 2400
"0001": 2400
"0010": 2800/2400
"0011": 3000/2800/2400
"0100": 3200/3000/2800/2400
"0101": 3429/3200/3000/2800/2400
When set at a value other than those shown above, the initial value of
"0101" is activated.
Setting to determine whether or not to limit FAX dial number display to
16 digits. When this is set to "1: Correspond," FAX number display
based on the resend key and the other party's number on the job status
completion screen are displayed from the start to the 16th digit. When
this SW is set as valid, it is also reflected in report contents.
"0": Do not correspond
"1": Correspond
FAX address display limit (displayed up to the 16th digit from the front)
This sets the waiting time from the end of line connection to the start of
dial call at times of automatic dial calling.
"00": 3.5 seconds
"01": 4 seconds
"10": 5 seconds
"11": 6 seconds
This only functions when dial tone detection is OFF.
This sets the waiting time from the end of line connection to the start of
dial call at times of automatic dial calling.
"00": 3.5 seconds
"01": 4 seconds
"10": 5 seconds
"11": 6 seconds
This only functions when dial tone detection is OFF.
Setting to determine how many seconds to prohibit waiting at both
speeds (slow and fast) after sending the CFR signal from the machine.
Binary inputting 200ms intervals
Setting range 200 - 2800ms
1600ms when "0000" is set.
0ms when "1111" is set.
This sets the ANSam signal sending time when the ANSam signal is
sent in the V.8 mode.
"00": 3 seconds
"01": 4 seconds
"10": 5 seconds
"11": 6 seconds
MX-FXX1 SIMULATIONS, FAX SOFTWARE SWITCH 5 – 34
Initial value
0 3429/3200/3000/2800/
2400
1
0
1
0
1
0
0
0
1
0
1
0
0 Do not correspond
0 3.5 seconds (North
America/Australia/France/
0
Germany/Sweden/
Switcherland/Austria/
China/Singapore/
Indonesia/Thailand/
Malaysia/India/Philippine/
Hong Kong/Taiwan/Middle
East/Other3/Rusia)
0 4 seconds (U.K./Finland/
Norway/Denmark/
1
Netherlands/Italy/New
Zealand/Slovakia/South
Africa/Spain/Portuguese/
Luxemburg/Belgium/
Czech/Hungary/Greece/
Poland)
1
0
1
0
0
1
1
0 1.5 seconds
0 1600ms
0
0
0
0
0
0 4 seconds
1
System
settings