Sharp MX-FXX1 Service Manual page 49

SW Bit
Item
No. No.
63 5-6 Lower limit of busy
tone OFF detection
time
7-8 Upper limit of busy
tone OFF detection
time
64 1-4 Not used
5-8 Call signal OFF non-
detection time
65 1-4 Lower limit of call
signal ON time
5-8 Upper limit of call
signal ON time
66 1-4 Lower limit of call
signal OFF time
SW selection and function
This sets the lower limit time of the OFF section when detecting
frequency of the busy tone signal.
If busy tone OFF signals are not detected in excess of this time, do not
count as 1 pulse.
"00": 250ms
"01": 140ms
"10": 450ms
"11": 350ms
This sets the upper limit time of the OFF section when detecting
frequency of the busy tone signal.
If busy tone signal is detected in excess of this time, do not count as 1
pulse.
"00": 750ms
"01": 650ms
"10": 1000ms
"11": 2850ms
This sets the time for ignoring OFF signals and regarding ON time to be
continuous following ON detection of the call signal (CI).
This is intended to treat the PBX call signal "ring-ring" as a single call
signal.
Setting can be made over the range of 0ms to 1500ms in 100ms
increments by binary inputting.
This sets the minimum ON time for detecting call signal (CI) pulses
(number of pulses). 1 pulse is counted if the CI signal remains ON for
the set ON time or longer.
Setting can be made over the range of 150ms to 300ms in 10ms
increments by binary inputting.
This sets the maximum ON time for detecting call signal (CI) pulses
(number of pulses). Disregard and do not count as 1 pulse if the CI
signal remains ON for the set ON time or longer.
Setting can be made over the range of 3000ms to 4500ms in 100ms
increments by binary inputting.
This sets the minimum OFF time for detecting call signal (CI) pulses
(number of pulses). 1 pulse is counted if the CI signal remains OFF for
the set OFF time or longer.
Setting can be made over the range of 100ms to 1500ms in 100ms
increments by binary inputting.
Setting range
When 0 is set, initial value 700ms operation takes place.
MX-FXX1 SIMULATIONS, FAX SOFTWARE SWITCH 5 – 40
Initial value
0 250ms (North America/
Australia/New Zealand/
0
China/Singapore/
Indonesia/Thailand/
Malaysia/India/Philippine/
Hong Kong/Taiwan/Middle
East/Other3/South Africa)
0 140ms (U.K./France/
Germany/Sweden/
1
Finland/Norway/Denmark/
Netherlands/Italy/
Switcherland/Austria/
Slovakia/Rusia/Spain/
Portuguese/Luxemburg/
Belgium/Czech/Hungary/
Greece/Poland)
0 750ms (North America/
Australia/U.K./France/
0
Germany/Sweden/
Finland/Norway/Denmark/
Netherlands/Italy/
Switcherland/Austria/New
Zealand/China/Indonesia/
Thailand/Malaysia/
Philippine/Hong Kong/
Taiwan/Middle East/
Slovakia/Other3/Rusia/
Spain/Portuguese/
Luxemburg/Belgium/
Czech/Hungary/Greece/
Poland)
1 1000ms (Singapore/India/
South Africa)
0
0
0
0
0
0 "0110": 600ms (North
America/Australia/Taiwan/
1
Middle East/Other3/Rusia)
1
"0100": 400ms (U.K./
0
France/Germany/Sweden/
Finland/Norway/Denmark/
Netherlands/Italy/
Switcherland/Austria/
China/Singapore/
Indonesia/Thailand/
Malaysia/India/Philippine/
Hong Kong/Slovakia/
South Africa/Spain/
Portuguese/Luxemburg/
Belgium/Czech/Hungary/
Greece/Poland)
"1010": 1000ms
(New Zealand)
0 "0000": 150ms
(Other country)
0
"0010": 170ms (Australia)
0
0
0 3000ms
0
0
0
0 700ms
1
1
1
System
settings