Sharp MX-FXX1 Service Manual page 37

SW Bit
Item
No. No.
27 1-8 External telephone off-
hook detection time
28 1-8 Not used
29 1-8 Not used
30 1-8 Not used
31 1-4 Not used
5 Document content print
when sending (PC-Fax
(Internet Fax) report
table)
6-8 Not used
32 1-4 T1 timer setting
5-8 Not used
33 1-2 T4 timer setting
Timer during automatic
operation (+1.5
seconds at times of
manual operation)
3 Not used
4 Selection of date and
transmission source
print language
<Format>
SW31, 1-4 Initial value
"0000": North America/Australia/U.K./Sweden/Finland/Norway/Denmark/Netherlands/Italy/Switcherland/Austria/New Zealand/China/Singapore/Indonesia/
Thailand/Malaysia/India/Philippine/Hong Kong/Taiwan/Middle East/Slovakia/Other3/Rusia/South Africa/Spain/Portuguese/Luxemburg/Belgium/Czech/
Hungary/Greece/Poland
"1100": France/Germany
SW selection and function
Set the time for detecting and confirming external telephone off-hook.
Setting can be made over the range of 0ms to 2550ms in 10ms
increments by binary inputting.
Setting to print images or not on the report table when sending PC-Fax
(Internet Fax).
"0": Not print
"1": Print
When the system setting is set so that images are added in the
communication report table, if the destination is a PC-Fax (Internet
Fax), the document contents are printed by this setting.
Setting to determine how many seconds the line is connected when the
other party's machine doesn't respond to FAX communication.
Setting can be made over the range of 30 to 105 seconds in 5-second
increments by binary inputting ((5 seconds x N) + 30 seconds).
T1 timer is the timer used from the point where the other party's
machine recognizes (CED or DCS) as FAX following line connection.
35±5 seconds according to the ITU-T standard.
This sets the timer for up until reception of the response.
+1.5 seconds at times of manual operation
"00": 3 seconds
"01": 4 seconds
"10": 5 seconds
"11": 6 seconds
This is the timer for up until reception of the response to the DCS
signal, etc. 3 seconds ±15% under the ITU-T standard.
Setting to determine the format of the date and transmission source
attached when transmitting FAX.
"0": Date format
"1": North American format
MX-FXX1 SIMULATIONS, FAX SOFTWARE SWITCH 5 – 28
Initial value
0 300ms
0
0
1
1
1
1
0
0
0
1
0
1
1
0
1
0
0
0
0
0
0
0
1
0
0 Refer to "SW31, 1-4 Initial
value"
0
0
0
0 Not print
1
0
1
0 40 seconds
0
1
0
0
0
0
0
0 3 seconds
0
0
0 Date format
System
settings