Before using the machine
•
Do not tilt the product at an angle of more than 10 degrees. Otherwise, it may fall over and cause
injury.
•
Always lock the wheels of this product after installation. Otherwise, it may fall over or slide and
cause injury
CAUTION:
To bundle wires and cables, always use the cable ties and spiral tubes supplied by
Xerox.
Other notices
•
To keep this product in a good performance and condition, always use it in the following
environment:
Temperature: 50
-
Humidity: 35
85%
-
•
When the product is left in a chilly room and the room is rapidly warmed up by heater, dew
condensation may form inside the product and cause a partial deletion on printing.
Operational safety
WARNINGS:
•
The operator's product maintenance procedures are described in the customer documentation
supplied with this product. Do not carry out any other maintenance procedures not described in
the documentation.
•
This product is equipped with a safety feature that prohibits access to hazardous areas. The areas
are isolated by covers or protectors that require a tool to remove. To prevent electric shock and
injury, never remove these covers and protectors.
1-8
° F (10 - 32° C)
90
WorkCentre 5019/5021
User Guide