Suzuki DL650 Service Manual page 383

8-26 ELECTRICAL SYSTEM
Repeat the above procedure a few times and measure the
highest ignition coil primary peak voltage.
g a
Tester knob indication: Voltage (=)
rn
Ignition coil primary peak voltage: 150 V and more
While testing, do not touch the tester probes and
spark plugs to prevent receiving an electric shock.
If the peak voltage is lower than the specified values, inspect
the ignition coil.
(-8-26)
IGNITION COIL RESISTANCE
Lift and support the fuel tank. (-5-7)
Disconnect the spark plug caps and ignition coil lead wires.
Measure the ignition coil resistance in both the primary and sec-
ondary windings. If the resistance is not within the standard
range, replace the ignition coil with a new one.
09900-25008: Multi circuit tester set
;u
Tester knob indication: Resistance (Q)
rn
lgnition coil resistance
Primary : 2
-
5 Q (@ terminal
-
@
terminal)
Secondary : 24
-
37 kQ (Plug cap
-
@
terminal)