Tps Adjustment - Suzuki DL650 Service Manual

4-16 FI SYSTEM DIAGNOSIS
-
CODE
C O O
C12
C13
C14
C15
C21
C23
C24
C25
C28
C29
C31
C32
C33
C41
C42
C44
C49
MALFUNCTION PART
None
Crankshaft position sensor (CKPS)
lntake air pressure sensor (IAPS)
Throttle position sensor (TPS)
Engine coolant temperature sensor (ECTS)
Intake air temperature sensor (IATS)
Tip over sensor (TOS)
lgnition signal #I (IG coil # I )
lgnition signal #2 (IG coil #2)
Secondary throttle valve actuator (STVA)
Secondary throttle position sensor (STPS)
Gear position signal (GP switch)
Fuel injector signal #1
Fuel injector signal #2
Fuel pump control system (FP control system)
Ignition switch signal (IG switch signal)
Heated oxygen sensor (H02S)
PAIR control solenoid valve
REMARKS
No defective part
Pick-up coil signal, signal generator
For #I cylinder
For #2 cylinder
For # I cylinder
For #2 cylinder
Fuel pump, Fuel pump relay
Anti-theft
For E-02, 19
In the LCD (DISPLAY) panel, the malfunction code is indicated from small code to large code.
TPS ADJUSTMENT
1. Warm up the engine and adjust the engine idle speed to
1 300
f
100 rpm. (-2-1 5)
2. Stop the engine.
3. Connect the special tool (Mode select switch) and select the
dealer mode.
4. If the throttle position sensor adjustment is necessary, loosen
the screws and turn the throttle position sensor and bring the
line to middle.
5. Then, tighten the screw to fix the throttle position sensor.
TP sensor mounting screw: 3.5 N-m (0.35 kgf-m, 2.5 Ib-ft)
@
Incorrect
@
Correct position
09930-1 1950: Torx wrench
09930-82720: Mode select switch