Using Testers - Suzuki DL650 Service Manual

4-8 FI SYSTEM DIAGNOSIS
USING TESTERS
Use the Suzuki multi-circuit tester set (09990-25008).
Use well-charged batteries in the tester.
Be sure to set the tester to the correct testing range.
USING THE TESTER
Incorrectly connecting the
@
and
@
probes may cause the
inside of the tester to burnout.
If the voltage and current are not known, make measure-
ments using the highest range.
When measuring the resistance with the multi-circuit tester
@ I ,
-
will be shown as 10.00 M i 2 and "1" flashes in the display.
Check that no voltage is applied before making the measure-
ment. If voltage is applied the tester may be damaged.
After using the tester, turn the power off.
09900-25008: Multi-circuit tester set
NOTE:
*
When connecting the multi-circuit tester, use the needle
pointed probe to the back side of the lead wire coupler and
connect the probes of tester to them.
*
Use the needle pointed probe to prevent the rubber of the
water proof coupler from damage.
e 0 9 9 0 0 - 2 5 0 0 9 : Needle Dointed Drobe set