Suzuki DL650 Service Manual page 149

3-98 ENGI N E
Fit the dowel pins
@
and new cylinder head gasket
@
to the
cylinder.
I
CAUTION
I
I
Use the new gasket t o prevent gas leakage.
1
Install the washers
@
to the cylinder head bolts (M10)
@
as
shown.
Apply engine oil to the washers and thread portion of the bolts
before installing the cylinder head bolts.
Place the rear cylinder head on the cylinder.
NOTE:
When installing the cylinder head, keep the cam chain taut.
Tighten the cylinder head bolts (M10) to the specified
two-step torque with a torque wrench sequentially and diago-
nally.
Cylinder head bolt (M10):
Initial 25 N-m (2.5 kgf-m, 18.0 Ib-ft)
Final 42 N-m (4.2 kgf-m, 30.5 Ib-ft)
After firmly tightening the cylinder head bolts (MlO), install the
cylinder head bolts (M6)
@,
0.
Tighten the cylinder head bolts
@,
0,
and cylinder nuts
@.