Suzuki DL650 Service Manual page 238

5-28 FUEL SYSTEM AND THROTTLE BODY
Connect the fuel injector couplers to the fuel injectors.
NOTE:
*
The fuel injector coupler No. 1 (FRONT) can be distinguished
from that of the No.2 (REAR) by the " F mark
@.
* Adjust the throttle cable play with the cable adjusters.
Refer to page 2- 15 for details.
STP SENSOR ADJUSTMENT
If the STP sensor adjustment is necessary, measure the sensor
resistance and adjust the STP sensor positioning as follows:
To set the ST valve to fully open position.
Measure the STP sensor voltage at fully open position.
STP sensor voltage
ST valve is fully opened: Approx. 4.38 V and more
(Yellow
-
Black)
rn
09900-25008: Multi circuit tester set
09900-25009: Needle pointed probe set
3 )
Tester knob indication: Voltage (--)
Do not use the tool for turning the STVA shaft to pre-
vent breakdown.
Loosen the STP sensor mounting screws.
Adjust the STP sensor until voltage is within specification and
tighten the STP sensor mounting screws.
rn
09930-1 1960: Torx wrench
-
STP sensor mounting screw:
2.0 N-m (0.2 kgf-m, 1.5 Ib-ft)
I
AIR CLEANER BOX INSTALLATION
Installation is in the reveres order of removal.