Suzuki DL650 Service Manual page 143

3-92
ENGINE
Install the clutch push rod
@
into the countershaft.
Install the clutch push piece
@,
the bearing
@
and thrust
washer
@
to the countershaft.
NOTE:
Thrust washer
@
is located between the pressure plate and
bearing
@.
Hold the generator rotor (crankshaft) with the special tool.
a
09930-44530: Rotor holder
Install the clutch pressure plate.
Tighten the clutch spring set bolts to the specified torque.
Clutch spring set bolt: 10 N m (1.0 kgf-rn, 7.0 Ib-ft)
NOTE:
Tighten the clutch spring set bolts diagonally.
CLUTCH COVER
Install the gasket and dowel pins
a.
I
Use the new gasket to prevent oil leakage.
I