Suzuki DL650 Service Manual page 341

7-70 CHASSIS
Assemble the insulator
@
and shim
@
to the new brake pad
8.
- 1
Replace the brake pads as a set, otherwise braking
performance will be adversely affected.
lnstall the new brake pads.
NOTE:
Make sure that the detent of the pad is seated onto the retainer
on the caliper bracket.
Tighten the caliper mounting bolt
a
and pad mounting pin
@
to the specified torque.
Rear brake caliper mounting bolt:
22 N-m (2.2 kgf-m, 16.0 Ib-ft)
Rear brake pad mounting pin:
17 N-m (1.7 kgf-m, 12.5 Ib-ft)
Install the plug
@
to the specified torque.
Pad pin plug: 2.5 N-m (0.25 kgf-m, 1.8 Ib-ft)
NOTE:
After replacing the brake pads, pump the brake pedal several
times in order to operate the brake correctly and then check the
brake fluid level.