Suzuki DL650 Service Manual page 304

CHASSI S 7-33
Set the punch mark
0
on the handlebar clamp forward.
Tighten the handlebar clamp bolts to the specified torque.
Handlebar clamp bolt: 23 N-m (2.3 kgf-m, 16.5 Ib-ft)
NOTE:
When tightening the handlebar clamp bolts, first tighten the
@
and then tighten the bolt
@.
bolt
HANDLEBAR SWITCH BOX
Install the throttle cable case.
Apply SUZUKI SUPER GREASE to the throttle cables and
their holes.
99000-25030: SUZUKl SUPER GREASE "A" (USA)
99000-2501 0: SUZUKl SUPER GREASE "A" (Others)
Align the mating surface @ I of the throttle case with the punch
mark
@
on the handlebars.
a
Install the right handlebar switch box to the handlebars by
engaging the stopper
@
with the handlebar's hole
a.
Install the front brake master cylinder.
( W 7 - 6 7 )
I
Install the handlebars with the punch mark
0
aligned with the
mating surface
0
of the clutch lever holder.
I
i