7-86 CHASSIS
After joining of the chain has been completed, check
to make sure that the link is smooth and no abnormal
condition is found.
Should any abnormal condition be found, reassem-
ble the chain link using the new joint parts.
Stake the joint pin by turning (approximately 718 turn) the
pressure bolt
" A
@
with the bar until the pin end diameter
becomes the specified dimension.
Pin end diameter specification
0
Adjust the drive chain, after connecting it. (-2-21)
DID
5.5
-
5.8 mm (0.21 7
-
0.228 in)