Suzuki DL650 Service Manual page 263

6-18 COOLI N G A N D LUBRICATION S Y S T E M
Install the new mechanical seal with the special tool.
09913-70210: Bearing installer set (@ 25 mm)
lnstall the new bearings with the special tool.
09913-70210: Bearing installer set
(4
25 mm)
NOTE:
The stamped mark on the bearing faces to the crankcase side.
Install the rubber seal
@
into the impeller.
After wiping off the oily or greasy matter from the mechanical
seal ring, install it into the impeller.
NOTE:
The paint marked side
@
of the mechanical seal ring faces to
the impeller.
Apply SUZUKl SUPER GREASE to the impeller shaft.
99000-25030: SUZUKI SUPER GREASE "A" (USA)
99000-25010: SUZUKl SUPER GREASE " A (Others)
lnstall the impeller to the water pump body.
Fix the impeller shaft with the E-ring
a.
Apply SUZUKI SUPER GREASE to the O-rings.
99000-25030: SUZUKI SUPER GREASE "A" (USA)
99000-25010: SUZUKl SUPER GREASE "A" (Others)
lnstall new O-rings
@.
Fill the bearing with engine oil until engine oil comes out from
the hole of the be bearing housing.