Suzuki DL650 Service Manual page 370

ELECTRICAL SYSTEM 8-13
Step3
1) Measure the starter relay voltage at the starter relay connectors (between B N and YIG) when the starter
button is pushed.
Is a voltage OK?
Faulty gear position switch.
Faulty starter button.
Faulty engine stop switch.
Faulty turn signallside-stand relay.
Faulty ignition switch.
Faulty clutch switch.
Faulty side-stand switch.
I
I
Improper connector contact.
I
I
Open circuit in wire harness.
Step4
1) Inspect the starter relay. ( W 8 - 1 9 )
Is the starter relay OK?
1
YES
I
Poor starter relav connection.
I
NO
/
Faulty starter relay.
I
The starter motor runs when the transmission is neutral with the side-stand up or down, but does not run
when the transmission is in any position other than neutral with the side-stand down.
I) Inspect the side-stand switch. ( - 8 - 2 0 )
Is the side-stand switch OK?
YES
Open circuit in wire harness.
Poor contact of connector.
NO
I
Faulty side-stand switch.
I
Engine does not turn though the starter motor runs.
Faulty starter clutch. ( W 3 - 7 9 )