Rap 68 E8: Oct Jam - Xerox DocuPrint N2025 Service Manual

RAP 68 E8: OCT Jam

There is a paper jam at the OCT Sensor.
Procedure
The front edge of the paper is located within the Exit Assembly.
Y N
Remove and reinstall the OCT Assembly (REP 10.1). Run a Test Print for simplex print.
The Error Code E4 still appears.
Y N
Problem solved.
The paper is discharged from the top of the OCT Assembly.
Y N
Rotate the 14/33 Idler Gear counter clockwise manually. Observe the correct contact
between the 14/33 Idler Gear and the 29 Gear and Offset Gear. All of the gears
rotate smoothly.
Y N
Replace parts as necessary (PL 13.1).
Run a Test print. Observe the rotation of the Inlet Roll and Offset Roll (REP 10.12).
The Inlet Roll and Offset Roll rotates in the same direction smoothly.
Y N
Replace the OCT Motor Assembly (REP 10.10).
Press and release the actuator of the Duplex Sensor (REP 9.6). The Duplex Sen-
sor actuates by lifting up the actuator and deactuates by releasing the actua-
tor.
Y N
Replace the OCT Sensor (REP 9.6).
Replace the Print Engine Controller PWB (REP 8.5).
Remove the Top Cover (REP 1.3). Remove the Rear Cover Assembly (REP 1.9). Rotate
the Inlet Roll counterclockwise manually. The Inlet Roll rotates smoothly.
Y N
Replace the OCT Assembly (REP 10.1).
Rotate the 14/33 Idler Gear counter clockwise manually. Observe the correct contact
between the 14/33 Idler Gear and the 29 Gear and Offset Gear. All of the gears rotate
smoothly.
Y N
Replace parts as necessary (PL 13.1).
Run a Test print. Observe the rotation of the Inlet Roll and Offset Roll. The Inlet Roll and
Offset Roll rotates in the same direction smoothly.
Y N
Replace the OCT Motor Assembly (REP 10.10).
Press and release the actuator of the OCT Sensor (REP 9.6). The OCT Sensor actu-
ates by lifting up the actuator and deactuates by releasing the actuator.
A
Initial Issue
DocuPrint N2025/N2825
A
Y N
Replace the OCT Sensor (REP 9.6).
Replace the Print Engine Controller PWB (REP 8.5).
Remove the Top Cover (REP 1.3). Remove the Rear Cover Assembly (REP 1.9). Rotate the
Inlet Roll counterclockwise manually. The Inlet Roll rotates smoothly.
Y N
Replace the OCT Assembly (REP 10.1).
Rotate the 14/33 Idler Gear counter clockwise manually. Observe the correct contact between
the 14/33 Idler Gear and the 29 Gear and Offset Gear. All of the gears rotate smoothly.
Y N
Replace parts as necessary (PL 13.1).
Run a Test print. Observe the rotation of the Inlet Roll and Offset Roll. The Inlet Roll and Off-
set Roll rotates in the same direction smoothly.
Y N
Replace the OCT Motor Assembly (REP 10.10).
Press and release the actuator of the OCT Sensor. The OCT Sensor actuates by lifting up
the actuator and deactuates by releasing the actuator.
Y N
Replace the OCT Sensor (REP 9.6).
Replace the Print Engine Controller PWB (REP 8.5).
02/2000
2-63
Status Indicator Repair Analysis Procedures
RAP 68