Duplex Assembly; Rep 9.1 Duplex Assembly; Rep 9.2 Exit Motor Assembly - Xerox DocuPrint N2025 Service Manual

REP 9.1 Duplex Assembly

Parts List on PL 13.1
Removal
Switch off the power and disconnect the Power Cord.
1. Open the Rear Cover.
2. Remove Left Cover (REP 1.1).
3. Pull the top of the Duplex Assembly away from the printer to disengage the two hooks
securing the unit (Figure 1).
4. Pull the Duplex Assembly out and up to remove (Figure 1).
Figure 1 Duplex Assembly
Replacement
1. Reinstall the components in the reverse order.
Initial Issue
DocuPrint N2025/N2825
WARNING

REP 9.2 Exit Motor Assembly

Parts List on PL 13.1
Removal
Switch off the power and disconnect the Power Cord.
1. Remove the Duplex Assembly (REP 9.1).
2. Remove the two screws that secure the Motor Assembly to the Duplex Assembly (Figure
1).
NOTE: There are different type and lengths of screws removed in Step 3.
3. Remove the harness from the cable clamp (Figure 1).
4. Disconnect P/J510 from the Duplex Assembly PWB (Figure 1).
5. Rotate the connector sideways and push the connector through the hole in the Duplex
frame (Figure 1).
6. Remove the motor cover (Figure 1).
7. Remove the two screws that secure the Exit Motor to the holder assembly (Figure 1).
Figure 1 Exit Motor Assembly
Replacement
1. Reinstall the components in the reverse order.
02/2000
4-51
WARNING
Repair-Adjustment
REP 9.1, REP 9.2