Rap 7.6 Paper Jam - Xerox DocuPrint P1202 Service Manual

RAP 7.6 Paper Jam

1 Visually inspect the paper for folded corners, lead edge damage, rips, or tears. The paper is free
of damage.
Y N
| Check paper path for obstructions, components out of place, damp or improperly installed
paper.
2 Check paper path for obstructions. Check BTR Roller for binding and for proper operation. Check
for defective Printer Cartridge. All items check OK.
Y N
| Repair or replace as necessary.
3 Disconnect the AC power. Connect the DCU and reconnect the AC power. Run a test print. The
DCU indicates a jam. Use Table 7.6 to isolate the problem.
Indication
Paper Jam 0.
Paper Jam 01
Paper Jam 02
Repair Analysis Procedures (RAP)
Table 7.6. Paper Jams.
Possible Cause
Paper Feed / Registration
Sensor or Sensor Actuator
Paper Feed / Registration
Sensor or Sensor Actuator
Fuser Assembly
Exit Drive Assembly
Fuser Assembly
www.printcopy.info
Use DCU test 08 to verify sensor. If OK replace the Engine
PWB (PL 7).
Use DCU test 08 to verify sensor. If OK replace the Engine
PWB (PL 7).
Verify Fuser Assembly is operational. Remove or replace as
necessary (PL 5).
Inspect Exit Sensor Actuator. Repair of replace as
necessary (PL 5).
Using DCU test 08, verify Fuser Exit Sensor is operational.
If OK, replace the Engine PWB (PL 7)
Inspect Exit Assembly. Repair or replace as necessary (PL
4).
Verify Fuser Assembly is operational. Remove or replace as
necessary (PL 5).
Inspect Exit Sensor Actuator. Repair of replace as
necessary (PL 5).
Using DCU test 08, verify Fuser Exit Sensor is operational.
If OK, replace the Engine PWB (PL 7).
3/99
7-10 Xerox DocuPrint P1202 Service Manual
Solution