REP 12.28 Right Tray Wires
Parts List on PL 12.4
Removal
Switch off the power and disconnect the Power Cord.
1.
Remove the 2000 Sheet Feeder Tray Assembly (REP 12.7).
2.
Remove the Shaft Cover Assembly (REP 12.24).
3.
Remove the Right Wire Cover (REP 12.23).
4.
Remove the E-ring that secures the Cable Pulley (Figure 1). Remove the pulley.
5.
Remove the E-rings and pulleys from the two shafts on the tray assembly (Figure 1).
6.
Remove the wires down through the holes in the tray assembly (Figure 1).
Figure 1 Right Tray Wires
Replacement
1.
Ensure the black plastic wire guides are at the top of the pulleys (Figure 1).
2.
Reinstall the components in the reverse order.
3.
The longer wire goes to the front of the tray.
Repair-Adjustment
REP 12.28, REP 12.29
WARNING
REP 12.29 Retard Assembly
Parts List on PL 12.3
Removal
Switch off the power and disconnect the Power Cord.
1.
Remove the 2000 Sheet Feeder Tray Assembly (REP 12.7).
2.
Remove the Right Side Cover (REP 12.5).
3.
Remove the E-ring that secures the 50T Gear to the Feeder Shaft (Figure 1). Remove the
gear.
4.
Remove the screw that secures the Stopper Gear (Figure 1). Remove the gear.
5.
Remove Gear 22T from the Retard Shaft (Figure 1).
6.
Open the Rear Door.
7.
Release the spring from the left end (as viewed from the rear) of the Retard Support (Fig-
ure 2).
8.
Remove the two screws that secure the Retard Support Assembly to the feeder (Figure
2).
9.
Lift the Retard Support Assembly, slide it to the right and remove (Figure 2).
02/2000
4-92
WARNING
Figure 1 Feed Gears
DocuPrint N2025/N2825
Initial Issue