Gp 5.4 Drive Power Transmission - Xerox DocuPrint N2025 Service Manual

GP 5.4 Drive Power Transmission

The drive power is generated by the Motor: Main and transmitted through the Gear Assembly:
Main and the gear trains to the printer components requiring mechanical drive.
As shown in the Figure below and the Figure on the next page, the drive power is distributed by
the Gear Assembly Figure 1: Main to the P/H Assembly, the Print Cartridge, the Chute Trans
Assembly and the Fuser Assembly.
The drive power transmitted to the P/H Assembly is then transmitted, through the Gear MBF
IN, to the MBF Feed Roll Assembly, the Roll Assembly Feed ENV and the Turn Roll Assembly.
The drive power transmitted to the Chute Trans Assembly drives the Metal Registration Roll
and Rubber Registration Roll.
The drive power transmitted to the Print Cartridge drives the Drum, and then it is transmitted to
the BTR in the Chute Trans Assembly through the Drum Gear.
The drive power transmitted to the Fuser Assembly drives the Heat Roll and the Drive Roll
Assembly Fuser. The power is further transmitted to the Roll Assembly Exit through the
Decurler Gear.
Figure 1 Drive Power Gear Assembly
General Procedures / Information Initial Issue
02/2000
GP 5.4
6-58 DocuPrint N2025/N2825