Xerox DocuPrint N2025 Service Manual page 323

Figure 7 OCT Major Components
Printer Control
The control of the printer against the OCT Assembly by the Controller is described here.
Control Timing of the Exit Gate Solenoid Figure 8
The Controller uses the signal /Reg. IN to change the discharging direction between the Exit
Assembly and OCT Assembly. The change of direction is made by the Chute Change Direc-
tion. When the lever of the Chute Change Direction is pushed up by the spindle of the Flapper
Solenoid, the paper is fed to the Assembly. When the Exit Gate Solenoid is ON and the spindle
is pulled down, the Chute Change Direction is released and returns to the position that the
paper is discharged to the standard exit tray. The timing chart shows the Exit Gate control at
simplex mode.
Initial Issue
DocuPrint N2025/N2825
Figure 8 Flapper Solenoid Control Timing
NOTE: For the description of the interface signals, Commands, and Statuses, refer to Control-
ler in Section 13 Principles of Operation of the Base Engine Service Manual.
Offset Paper Exit
When the OCT Assembly is selected as the exit tray (STATUS 13 bit 4=1) and the Offset Func-
tion of OCT is effective (STATUS 13 bit1=1), the paper is discharged to the offset position. If the
Offset Function is not effective (STATUS 13 bit1=0), the paper is discharged to the normal posi-
tion. The distance between the offset position and the normal position is approx. 25mm.
Available Paper Size
The paper sizes available for the Offset Function are as follows;
Ledger (SEF), Letter (SEF), DL, Letter (LEF), A3 (SEF), A4 (SEF), A4 (LEF), Post Card, B4
(SEF), B5 (SEF), Monarch, Statement (LEF), Legal 13", COM-10, Executive, B5 (LEF), Legal
14", C5, A5 (LEF)
02/2000
6-91
General Procedures / Information
GP 5.23