Rap 56 C5: Add Paper To Tray 2 (Or Tray 3) - Xerox DocuPrint N2025 Service Manual

RAP 56 C5: Add Paper To Tray 2 (or Tray 3)

Tray 2 or Tray 3 are out of paper.
Procedure
Check the paper level in the indicated Tray Assembly. There is paper in the indicated Tray.
Y N
Load paper into the Tray.
Remove the Tray from the 500 Sheet Feeder Assembly. Remove the Tray Cover and all paper
from the tray. Insert the Tray into the 500 Sheet Feeder Assembly and inspect the Bottom
Plate. The Bottom Plate is raised.
Y N
Replace the Tray 1 (PL 2.1/ PL 2.2).
Remove the Paper Tray. Manually actuate the No Paper Actuator. The No Paper Actuator
moves smoothly.
Y N
Replace the No Paper Actuator (REP 11.21).
Enter Diagnostics and select Component Test. Scroll to Sensor Input test and press Enter.
Press and release the No Paper Actuator. The number on the LCD increments each time
you press and release the actuator.
Y N
Switch the printer power off. Remove the 500 Sheet Feeder Left Cover (REP 11.3). Dis-
connect P/J133 from the Feeder PWB. Switch the printer power on. Measure the voltage
between P133 pin 4 and frame ground and between P133 pin 6 and frame ground. Both
readings are +3.2VDC.
Y N
Replace the Feeder PWB (REP 11.8).
Switch the printer power off. Reconnect P/J133. Switch the printer power on. Measure the
voltage between P/J133 pin 6 and frame ground as you actuate and deactuate the No
Paper Sensor. The voltage is +3.2VDC when deactuated and 0.0VDC when actuated.
Y N
Check for continuity between P/J133 and P/J13A and between P/J13A and P/J134.
Repair or replace as necessary. If the harness checks good, replace the No Paper
Sensor (REP 11.20).
Measure the voltage between P/J132 pin 7 and frame ground as you actuate and deactu-
ate the No Paper Sensor. The voltage is +0.9VDC when deactuated and 2.76VDC
when actuated.
Y N
Replace the Feeder PWB (REP 11.8).
Switch the printer power off. Remove the printer Left Side Cover (REP 1.1) and the Print
Engine Controller PWB Cover (REP 8.5). Switch the printer power on. Measure the volt-
age between P/J13 pin 7 and frame ground as you actuate and deactuate the No Paper
Sensor. The voltage is +0.9VDC when deactuated and 2.76VDC when actuated.
Y N
Check for continuity between P/J132 and P/J131 and between P/J131 and P/J13.
Repair or replace as necessary.
A B
Initial Issue
DocuPrint N2025/N2825
A B
Replace the Print Engine Controller PWB (REP 8.5).
Replace the Print Engine Controller PWB (REP 8.5).
02/2000
2-53
Status Indicator Repair Analysis Procedures
RAP 56