Xerox DocuPrint N2025 Service Manual page 310

NOTE: If the Fuser temperature has not yet reached the PAPER FEED START Temperature in
the Thick Paper mode when the printer starts the print operation (that is, when the printer
begins to feed paper), the printer does not start the print operation until the Fuser temperature
reaches the PAPER FEED START Temperature.
Fuser Temperature Code Table Table 5
Table 5 Fuser Temperature Codes
Fuser Fuser
Temp. Temp. Temp. Temp.
(°C) Code (hex) (°C) Code (hex)
0 EE 110 E4(E1-E6) 180
- - - -
10 FE(FD-FE) 120 DE(DB-E0) 185
- - - -
20 FD 130 D6(D3-D9) 190
- - - -
30 FD(FC-FD) 140 CF(CB-D2) 195
- - - -
40 FB(FA-FC) 145 CB(C7-CE) 200
- - - -
50 F9(F8-FA) 150 C6(C3-CA) 205
- - - -
60 F7(F6-F8) 155 C2(BE-C5) 210
- - - -
70 F5(F3-F6) 160 BD(BA-C1) 215
- - - -
80 F2(F0-F3) 165 B9(B5-BC) 220
- - - -
90 EE(EC-F0) 170 B4(B0-B7) 225
- - - -
100 E9(E7-EB) 175 AF(AB-B3) 230
- - - -
Erase Cycle
The printer executes the Erase Cycle when printer power is turned on or the interlock switches
are actuated. During an Erase Cycle, the printer runs the Motor:Main, actuates the Registration
Clutch, and Turn Clutch Assembly and outputs the CR(AC), CR(DC), DTS, and BTR(-) volt-
ages from the HVPS to clean the drum surface and drive the paper remaining in the printer to a
sensor for detection.
General Procedures / Information
GP 5.20
Fuser
Temp. Temp.
(°C) Code (hex)
AA(A7-AE0
- -
A5(A2-A9)
- -
A0(9C-A4)
- -
9B(97-9F)
- -
96(92-9A)
- -
91(8D-96)
- -
8C(88-91)
- -
88(83-8C)
- -
83(7E-88)
- -
7E(79-83)
- -
79(74-7E)
- -
NOTE: The printer interrupts the Erase Cycle when the interlock switches are deactuated, or
the Registration Sensor, Exit Sensor or Sensor Assembly Dup is actuated during the Erase
Cycle. It restarts the Erase Cycle when the interlock switches are actuated again, or printer
power is switched off and back on again.
The printer does not start an Erase Cycle if the Registration Sensor, Exit Sensor, or Sensor
Assembly Dup is being actuated or the Print Cartridge is not in place when the interlock
switches are actuated or printer power is switched on.
Fan Control
The printer switches the speed of the Fan between High and Low.
-High Speed: When the Main Motor is rotating
-Low Speed: When the Main Motor is stopped
When printer power is switched on, the Fan rotates at High Speed, then switches to Low
Speed.
02/2000
6-78
Initial Issue
DocuPrint N2025/N2825