Rap 23 J5 Toner Low - Xerox DocuPrint N2025 Service Manual

A
Replace the Print Engine Controller PWB (REP 8.5).
Table 1 Paper Size Actuators
8.5 A4 B5
Actuator LEF LEF LEF
4 Top x
3 x x x
2 x
1 Bottom x x x
Status Indicator Repair Analysis Procedures
RAP 22, RAP 23
A5 14" 8.5" A4 B4
LEF SEF SEF SEF SEF
x x x x
x x
x x x
x

RAP 23 J5 Toner Low

J5 is not displayed when the Print Cartridge appears to be empty.
Procedure
Run a Test Print. Inspect the print quality. The print is light.
Y N
Problem does not exist. Return to Initial Actions.
Replace the Print Cartridge (PL 8.1). Run 5 test prints (Config Sheet or Demo Page) and
inspect the print quality. The print quality meets specifications.
Y N
Go to IQ RAP 1.
Remove Tray 1. Remove the MBF (REP 2.1). Enter Diagnostics and select Component Test.
Scroll to Sensor Input and press Enter [4]. Open the MBF Cover and carefully pull down then
release the Toner Sensor. The number on the LCD increments each time you pull down
and release the Toner Sensor.
Y N
Go to RAP 42.
Replace the Print Engine Controller PWB (REP 8.5).
02/2000
2-26
Initial Issue
DocuPrint N2025/N2825