Cluster Outside-Interface - Cisco Catalyst 3550 Command Reference Manual

cluster outside-interface

cluster outside-interface
Use the cluster outside-interface global configuration command to configure the outside interface for
cluster Network Address Translation (NAT) so that a member without an IP address can communicate
with devices outside the cluster. Use the no form of this command to return to the default setting.
Syntax Description
interface-id
Defaults
The default outside interface is automatically selected by the command switch.
Command Modes
Global configuration
Command History Release
12.1(4)EA1
Usage Guidelines
Enter this command only on the command switch. If you enter this command on a member switch, an
error message appears.
Examples
This example shows how to set the outside interface to VLAN 1:
Switch(config)# cluster outside-interface vlan 1
You can verify your setting by entering the show running-config privileged EXEC command.
Related Commands Command
show running-config
Catalyst 3550 Multilayer Switch Command Reference
2-64
cluster outside-interface interface-id
no cluster outside-interface
Modification
This command was introduced.
Interface to serve as the outside interface. Valid interfaces include
physical interfaces, port-channels, or VLANs. The port-channel
range is 1 to 64. The VLAN range is 1 to 4094.
Description
Displays the current operating configuration. For syntax information,
select Cisco IOS Release 12.2 Configuration Guides and Command
References > Cisco IOS Configuration Fundamentals Command
Reference, Release 12.2 > File Management Commands >
Configuration File Management Commands.
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
OL-8566-02