Cisco SPS208G User Manual page 38

Port Management
Port Settings
SPS208G/SPS224G4/SPS2024 Service Provider Switches User Guide
-
MDIX
— Use for end stations.
-
MDI
— Use for hubs and switches.
•
Flow Control — Displays the flow control status on the port. Operates when
the port is in full duplex mode. The possible values are:
-
Enable — Flow control on the port is enabled.
-
Disable
— Flow control on the port is disabled.
-
Auto-Negotiate
enabled.
•
Type — Displays the port type.
•
LAG — Indicates in which LAG the port is a member.
•
PVE — Indicates that this port is protected by an uplink, so that the
forwarding decisions are overwritten by those of the port that protects it.
PVE is supported in Layer 2 mode.
— Auto-negotiation of flow control on the port is
3
38