Cisco SPS208G User Manual page 236

SNMP
Notification Recipient
SPS208G/SPS224G4/SPS2024 Service Provider Switches User Guide
The Notification Recipient Parameters area contains the following fields:
•
Recipient IP — Indicates the IP address to whom the traps are sent.
•
Notification Type — Defines the notification sent. The possible field values
are:
-
Traps — Indicates traps are sent.
-
Informs
— Indicates informs are sent.
Either SNMPv1,2 or SNMPv3 can be enabled at any one time, but not both at the
same time.
•
SNMPv1,2 — Enables SNMPv1,2 as the Notification Recipient.
•
Community String — Identifies the community string of the trap manager.
•
Notification Version — Determines the trap type. The possible field values
are:
-
SNMP V1
— Indicates SNMP Version 1 traps are sent.
-
SNMP V2 — Indicates SNMP Version 2 traps are sent.
•
SNMPv3 — Enables SNMPv3 as the Notification Recipient.
•
User Name — Defines the user to whom SNMP notifications are sent.
•
Security Level — Defines the means by which the packet is authenticated.
The possible field values are:
-
No Authentication
encrypted.
-
Authentication
-
Privacy
— Indicates the packet is both authenticated and encrypted.
•
UDP Port — Displays the UDP port used to send notifications. The default is
162.
•
Filter Name — Indicates the SNMP filter (defined in the
Screen ) that specifies the traps which this user receives.
•
Timeout — Indicates the amount of time (seconds) the device waits before
re-sending an inform request. The range is 1-300 seconds. The default is 15
seconds.
•
Retries — Indicates the number of times the device re-sends an inform
request. The range is 0-255 times. The default is 3 times.
— Indicates the packet is neither authenticated nor
— Indicates the packet is authenticated.
12
Notification Filter
236