Cisco SPS208G User Manual page 197

Spanning Tree
RSTP Port Settings
SPS208G/SPS224G4/SPS2024 Service Provider Switches User Guide
•
Port State — Indicates the RSTP status on the specific port. The possible
field values are:
-
Disabled
— Indicates that STP is currently disabled on the port or if the
port is not active. The port forwards traffic while learning MAC
addresses.
-
Blocking
— Indicates that the port is currently blocked and cannot
forward traffic or learn MAC addresses.
-
Listening
— Indicates that the port is in Listening mode. The port cannot
forward traffic nor can it learn MAC addresses.
-
Learning
— Indicates that the port is in Learning mode. The port cannot
forward traffic, however it can learn new MAC addresses.
-
Forwarding
— Indicates that the port is in Forwarding mode. The port
can forward traffic and learn new MAC addresses.
•
Point-to-Point Admin Status — Indicates whether a point-to-point link is
established on the port. Ports defined as Full Duplex are considered Point-
to-Point port links. The possible field values are:
-
Enable
— Device establishes point-to-point, full duplex links.
-
Disable
— Device establishes shared, half duplex links.
-
Auto
— Device automatically determines the state.
•
Point-to-Point Oper Status — Indicates the Point-to-Point operating state.
•
Activate Protocol Migration Test — Click the
Protocol Migration Test. The test identifies the STP mode of the interface
connected to the selected interface.
Activate
button to run a
10
197