Using the CLI to Configure Filter Control and VLANs
CLI Commands for VLAN Support
From the global configuration mode, use the management‐vlanid command to set the default
Management VLAN ID for the Ethernet interface. VLAN tagging is enabled by default, and
cannot be disabled. To view the current management VLAN settings, use the show system
command.
Example
RoamAbout 4102#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 4102(config)#management-vlanid 3
Reboot system now? <y/n>: y
Username: admin
Password:********
RoamAbout 4102#show system
System Information
====================================================================
Serial Number
System Up time
System Name
System Location
System Contact
System Country Code : SG - SINGAPORE
Ethernet MAC Address : 00-01-F4-61-9C-08
802.11a MAC Address
802.11b/g MAC Address : Default=00-0C-DB-81-3D-CD
IP Address
Subnet Mask
Default Gateway
Management VLAN ID(AP : 3
IAPP State
DHCP Client
HTTP Server
HTTP Server Port
HTTPS Server
HTTPS Server Port
Slot Status
SSH Server
SSH Server Port
Telnet Server
Com Port
Software Version
====================================================================
RoamAbout 4102#
: 034830992141
: 0 days, 5 hours, 8 minutes, 42 seconds
: RoamAbout AP
:
:
: Default=00-01-F4-61-9C-36 VAP1=00-01-F4-36-3C-36
VAP2=00-01-F4-36-4C-36
VAP4=00-01-F4-36-6C-36
VAP6=00-01-F4-36-8C-36
VAP2=00-0C-DB-81-3D-CF
VAP4=00-0C-DB-81-3D-D1
VAP6=00-0C-DB-81-3D-D3
: 10.2.43.203
: 255.255.0.0
: 10.2.1.1
: ENABLED
: DISABLED
: ENABLED
: 80
: ENABLED
: 443
: Dual band(a/g)
: ENABLED
: 22
: ENABLED
: ENABLED
: V1.0.16
RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-19
Filter Control and VLANs
VAP3=00-01-F4-36-5C-36
VAP5=00-01-F4-36-7C-36
VAP7=00-01-F4-36-9C-36
VAP1=00-0C-DB-81-3D-CE
VAP3=00-0C-DB-81-3D-D0
VAP5=00-0C-DB-81-3D-D2
VAP7=00-0C-DB-81-3D-D4