Table of Contents
Advertisement
Configuring the RoamAbout R1 for PPPoE
Perform the following steps to configure the RoamAbout R1 for PPPoE:
1.
Click on WAN in the Main page.
2.
Click on the PPP over Ethernet radio button, and then click on More Configuration.
3.
Enter the User Name and Password required by your ISP in the appropriate fields.
Enter the password again for verification in the Please retype password field.
4.
If your ISP has provided you with a Service Name enter it in the Service Name field,
otherwise, leave it blank.
5.
Click SAVE when finished.
6.
If you are connecting to the Internet through PPPoE, you probably do not need to enter
anything here. However, if there is another DNS server that you would rather use,
enter the DNS server addresses in the spaces provided.
7.
Click SAVE when finished.
Many ISP's use modems that automatically configure. Sometimes connection
information is stored on the modem and needs to be updated. You may need to shut
down and restart your modem after the configured is complete.
8.
Restart your modem by removing the power, wait a few seconds, and then reconnect
the power.
The configuration is complete and your RoamAbout R1 is now connected to the
Internet. There are also some advanced configuration options that may be configured,
but changing these options is not recommended unless needed. For instructions for the
advanced configuration options, refer to the RoamAbout R1 SOHO Access Point
User's Guide located on the CD.
4-7
Advertisement
Table of Contents
