Pimsn Messages - Cisco Catalyst 3750-X Message Manual

Chapter 2 Message and Recovery Procedures
Error Message PHY-4-SFP_NOT_SUPPORTED: The SFP in [chars] is not supported
Error Message PHY-4-UNSUPPORTED_SFP_CARRIER: Unsupported SFP carrier module found in
[chars]
Error Message PHY-4-UNSUPPORTED_TRANSCEIVER:Unsupported transceiver found in
[chars]

PIMSN Messages

Error Message PIMSN-6-IGMPSN_GLOBAL: PIM Snooping global runtime mode [chars] due to
IGMP Snooping [chars].
OL-9772-05
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
The SFP module type is not supported on this switch. [chars] is the interface.
Explanation
Remove the unsupported SFP module, and get a supported SFP module.
Recommended Action
The SFP carrier module was identified as an unsupported, non-Cisco SFP carrier
Explanation
module. [chars] is the unsupported module.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
Explanation The SFP module was identified as an unsupported, non-Cisco SFP module. [chars] is
the unsupported module.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
"Error Message Traceback Reports" section on page 1-5.
When IGMP snooping is disabled, PIM snooping is disabled. When IGMP snooping is
Explanation
re-enabled, PIM snooping is re-enabled. The first [chars] is the PIM snooping mode, and the second
[chars] is the IGMP snooping mode.
No action is required.
Recommended Action
1-7.
1-7.
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
PIMSN Messages
"Error
"Error
2-53