Backup_Interface Messages; Badtransceiver Messages - Cisco Catalyst 3750-X Message Manual

Chapter 2 Message and Recovery Procedures
Error Message AUTHMGR-7-RESULT: Authentication result [chars] from [chars] for
client [chars] on Interface [chars] AuditSessionID [chars]
Explanation
second [chars] is the authentication method, the third [chars] is the client ID, the fourth [chars] is the
interface, and the fifth [chars] is the session ID.

BACKUP_INTERFACE Messages

Error Message BACKUP_INTERFACE-5-PREEMPT: Preempting interface [chars] in backup
pair ([chars], [chars]), preemption mode is [chars]
Error Message BACKUP_INTERFACE-5-VLB_NON_TRUNK: Warning:
allowed on non-trunk ports.

BADTRANSCEIVER Messages

Error Message BADTRANSCEIVER, PHY, LOG_WARNING: An innapropriate transceiver has
been inserted in interface [chars].
OL-9772-05
The results of the authentication. The first [chars] is the status of the authentication, the
Recommended Action No action is required.
The switch is preempting the current forwarding interface in the backup interface pair.
Explanation
The first [chars] is the number of the current forwarding interface. The second and third [chars] are
the names of the interfaces in the backup pair, and the fourth [chars] is the pre-preemption mode.
No action is required.
Recommended Action
Explanation Flex Link VLAN load-balancing (VLB) detects a nontrunk port. [chars] is the interface
name.
Change the interface to trunking mode.
Recommended Action
A defective module is installed in the specified interface. [chars] is the interface.
Explanation
Remove the transceiver. If it was purchased from Cisco, contact your Cisco
Recommended Action
representative to have the transceiver replaced.
Please configure [chars] to be a trunk port.
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
BACKUP_INTERFACE Messages
Flexlink VLB is not
2-9