Cisco Catalyst 3750-X Message Manual page 30

CFGMGR Messages
Error Message CFGMGR-4-MEMBER_WRITING_STARTUP_CFG: only master can do that.
Explanation
stack master can write to the startup configuration file.
Recommended Action
Error Message CFGMGR-5-UNABLE_TO_USE_PROVISIONED_CFG: Switch [dec] will receive the
default configuration.
Explanation
for its switch number. The default configuration is applied to this switch. [dec] is the stack member
number.
Recommended Action
Error Message CFGMGR-6-APPLYING_RUNNING_CFG: as new master.
Explanation
Recommended Action
Error Message CFGMGR-6-SPURIOUS_MEMBER_ADD: CFG MGR Recvd Spurious New Member
Notification: [int].
Explanation
that already exists in the stack. [int] is the switch number.
Recommended Action
system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug
Toolkit to look for similar reported problems. If you still require assistance, open a case with the
TAC, or contact your Cisco technical support representative, and provide the representative with the
gathered information. For more information about these online tools and about contacting Cisco, see the
"Error Message Traceback Reports" section on page
Error Message CFGMGR-6-UNABLE_TO_NVGEN_BUSY_RUNNING_CFG: config file busy,
retrying...
Explanation
because another process is generating the configuration file.
Recommended Action
Error Message CFGMGR-6-UNABLE_TO_NVGEN_RUNNING_CFG: config file too large...
Explanation
configuration file is too large.
Recommended Action
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
2-12
A stack member switch attempted to write to the startup configuration file. Only the
No action is required.
The switch type of the specified switch does not match the provisioned configuration
No action is required.
A new stack master is applying the backed-up running configuration.
No action is required.
The configuration manager received a notification about adding a stack member switch
If this message recurs, copy it exactly as it appears on the console or in the
The stack master is temporarily unable to generate the stack running configuration
No action is required. The action will be tried again.
The stack master cannot generate the stack running configuration because the
Remove some configuration commands.
Chapter 2 Message and Recovery Procedures
1-7.
OL-9772-05