Authmgr Messages - Cisco Catalyst 3750-X Message Manual

Hide thumbs Also See for Catalyst 3750-X:
Table of Contents

Advertisement

AUTHMGR Messages

AUTHMGR Messages
Error Message AUTHMGR-5-SECURITY_VIOLATION: Security violation on the interface
[chars], new MAC address ([enet) is seen. AuditSessionID [chars]
Explanation
authenticate. The interface mode does not support the number of hosts that are attached to the
interface. This is a security violation, and the interface has been error disabled. The first [chars] is
the interface, [enet] is the Ethernet address of the host, and the second [chars] is the session ID.
Recommended Action
hosts. Enter the shutdown interface configuration command followed by no shutdown interface
configuration command to restart the interface.
Error Message AUTHMGR-5-VLANASSIGN: VLAN [dec] assigned to Interface [chars]
AuditSessionID [chars]
Explanation
second [chars] is the session ID.
Recommended Action
Error Message AUTHMGR-7-FAILOVER: Failing over from [chars] for client ([chars]) on
Interface [chars] AuditSessionID [chars]
Explanation
another method. The first [chars] is the current authentication method, the second [chars] is the
client ID, the third [chars] is the interface, and the fourth [chars] is the session ID.
Recommended Action
Error Message AUTHMGR-7-NOMOREMETHODS: Exhausted all authentication methods for
client ([chars]) on Interface [chars] AuditSessionID [chars]
Explanation
failed. The first [chars] is the client ID, the second [chars] is the interface, and the third [chars] is the
session ID.
Recommended Action
authorized based on the local authorization method. Otherwise, authentication restarts according to
the configured reauthentication period.
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
2-8
A host on the interface attempted to gain access to the network or attempted to
Make sure that the interface is configured to support the number of attached
A VLAN was assigned. [dec] is the VLAN ID, the first [chars] is the interface, and the
No action is required.
The authorization manager is failing over from the current authentication method to
No action is required.
All available authentication methods have been tried for the client, but authentication has
No action is required. If local authorization has been configured, the port is
Chapter 2
Message and Recovery Procedures
OL-9772-05

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 3560-xCatalyst 3560-eCatalyst 3750-e

Table of Contents