Spantree Messages - Cisco Catalyst 3750-X Message Manual

Chapter 2 Message and Recovery Procedures
Error Message SPAN-3-UNKN_ERR_PORT: An internal error occurred when configuring SPAN
on port [chars].

SPANTREE Messages

Error Message SPANTREE-2-BLOCK_BPDUGUARD: Received BPDU on port [chars] with BPDU
Guard enabled. Disabling port.
Error Message SPANTREE-2-BLOCK_BPDUGUARD_VP: Received BPDU on port [chars], vlan
[dec] with BPDU Guard enabled. Disabling vlan.
Error Message SPANTREE-2-BLOCK_PVID_LOCAL: Blocking [chars] on [chars]. Inconsistent
local vlan.
OL-9772-05
Explanation SPAN detected an error in its internal operation. [chars] is the interface.
The error might be transient. Try the SPAN operation again. If the second
Recommended Action
attempt also fails, reload the switch by using the reload privileged EXEC command to complete the
operation.
A BPDU was received on an interface that has the spanning tree BPDU guard feature
Explanation
enabled. As a result, the interface was administratively shut down. [chars] is the interface name.
Either remove the device sending BPDUs, or disable the BPDU guard feature.
Recommended Action
The BPDU guard feature can be locally configured on the interface or globally configured on all
ports that have PortFast enabled. To disable BPDU guard on an interface, use the no spanning-tree
bpduguard enable interface configuration command. To disable BPDU guard globally, use the no
spanning-tree portfast bpduguard default global configuration command. After you have
removed the device or disabled BPDU guard, re-enable the interface by entering the no shutdown
interface configuration command.
A BPDU was received on the interface and the VLAN. The spanning tree BPDU guard
Explanation
feature was enabled and configured to shut down the VLAN. The VLAN was error disabled. [chars]
is the interface, and [dec] is the VLAN.
Either remove the device sending BPDUs, or disable the BPDU guard feature.
Recommended Action
The BPDU guard feature can be configured locally on the interface or globally on all ports that have
Port Fast enabled. To re-enable the interface and the VLAN, use the clear errdisable privileged
EXEC command.
The spanning-tree port associated with the listed spanning-tree instance and interface
Explanation
will be held in the spanning-tree blocking state until the port VLAN ID (PVID) inconsistency is
resolved. The listed spanning-tree instance is that of the native VLAN ID of the listed interface. The
first [chars] is the interface, and the second [chars] is the spanning-tree instance.
Verify that the configuration of the native VLAN ID is consistent on the
Recommended Action
interfaces on each end of the 802.1Q trunk connection. When corrected, spanning tree automatically
unblocks the interfaces, as appropriate.
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
SPANTREE Messages
2-99