Platform_Ipv6_Ucast Messages; Platform_Pbr Messages - Cisco Catalyst 3750-X Message Manual

PLATFORM_IPv6_UCAST Messages

Error Message PLATFORM_IPC-3-STACK_EVENT: [chars].
Note
PLATFORM_IPv6_UCAST Messages
Error Message PLATFORM_IPv6_UCAST-6-PREFIX: One or more, more specific prefixes
could not be programmed into TCAM and are being covered by a less specific prefix
Note

PLATFORM_PBR Messages

Error Message PLATFORM_PBR-2-NO_RMAP: Cannot create PBR data structures for
route-map [chars].
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
2-64
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
This message applies only to the Catalyst 3750-X and 3750-E switches.
There has been an IPC failure in the stack. [chars] describes the error message.
Explanation
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
This message applies only to the Catalyst 3750-X and 3750-E switches.
A more specific prefix could not be programmed into Ternary Content Addressable
Explanation
Memory (TCAM) and is covered by a less specific prefix. This could be a temporary condition. The
output of the show platform ipv6 unicast retry route privileged EXEC command lists the failed
prefixes.
No action is required.
Recommended Action
The PBR manager could not allocate the internal data structures for this route-map. A
Explanation
likely cause is lack of available memory. [chars] is the route-map.
Recommended Action Simplify the configuration so that it requires less memory.
Chapter 2 Message and Recovery Procedures
1-7.
1-7.
"Error
"Error
OL-9772-05