Authmgr Messages - Cisco 3845 - Security Bundle Router Manual

AUTHMGR Messages

Error Message ACLMGR-3-RELOADED: Reloading [chars] label [dec] feature.
Error Message ACLMGR-3-UNKNOWNACTION: Unknown VMR access group action [hex].
Error Message ACLMGR-3-UNLOADING: Unloading [chars] label [dec] feature.
AUTHMGR Messages
Error Message AUTHMGR-5-SECURITY_VIOLATION: Security violation on the interface
[chars], new MAC address ([enet) is seen. AuditSessionID [chars]
Explanation
The interface mode does not support the number of hosts that are attached to the interface. This is a
security violation, and the interface has been error-disabled. The first [chars] is the interface, [enet]
is the Ethernet address of the host, and the second [chars] is the session ID.
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
2-6
The ACL manager can now load more of the configured features on this label into the
Explanation
hardware. One or more features had previously been unloaded because of lack of space. [chars] is
the direction (input or output), and [dec] is the label number.
No action is required.
Recommended Action
An internal software error has occurred. [hex] is an internal action code.
Explanation
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the
page 1-5.
The ACL manager could not fit the complete configuration into the hardware, so some
Explanation
features will be applied in the software. Some or all of the packets in a VLAN are forwarded by the
CPU. Multicast packets might be dropped entirely instead of being forwarded. [chars] is the
direction (input or output), and [dec] is the label number.
Use a simpler configuration. Use the same ACLs on multiple interfaces, if
Recommended Action
possible.
A host on the interface attempted to access the network or attempted an authentication.
Make sure that the interface is configured to support the number of hosts that
Recommended Action
are attached to it. Enter the shutdown interface configuration command followed by no shutdown
interface configuration command to restart the interface.
Chapter 2 Messages and Recovery Procedures
"Error Message Traceback Reports" section on
OL-23408-01