Konica Minolta 7085 Instruction Manual page 112

Remove any document from the platen glass or from the document feeder, if
present.
3.
Position original(s).
See p. 3-2 to p. 3-6 for details on positioning originals.
4.
Press [START] to start the interrupt copying.
When [CHECK] is pressed during Interrupt copying, the information
displayed reflects the initial copy job settings. Check mode will not display
Interrupt copy job information.
5.
When Interrupt copying is completed, press [INTERRUPT] again.
The [INTERRUPT] LED turns out and the INTERRUPT indicator on the Basic Screen
returns to the JOB indicators.
The settings of the initial job will be restored on the Basic Screen.
6.
Press [START] to resume copying.
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
For particular jobs in progress, copying will cease only after certain phases
of the immediate operation are completed, as indicated by the [INTER-
RUPT] LED conditions described below.
• Collectively printing image stored in memory
• Scanning originals into memory
• Scanning originals into memory while printing in Reserve mode
3-54
DETAILS
HINT
DETAILS
CAUTION
DETAILS
The LED blinks until one set of the current job is printed.
Then the LED remains steady for the temporary job performed in
Interrupt mode.
The LED blinks until scanning is completed for all originals placed in the
document feeder.
Then, the LED remains steady for the temporary job performed in
Interrupt mode.
The LED blinks until the copier completes the current printing job, scans
all originals placed on the document feeder, and prints one set of the
Reserved job.
The LED remains steady for the temporary job performed in Interrupt
mode.
Interrupt Copying (continued)