Konica Minolta 7085 Instruction Manual page 110

Checking Feature Selections and Proof Copying (continued)
6.
Press [PROOF COPY] on the control panel or touch PROOF COPY on
the Check Screen.
A sample copy will be output.
• Press [STOP] to suspend the proof copying. In this case, the scanned
• You cannot change or release selections that appeared dimmed after
• When the copy result is satisfactory, proceed to the next step.
• When any setting change is required, return to step 4, then repeat proof copying, as
required.
If the desired selection cannot be changed, press [STOP] to delete all the data in
memory, then press [AUTO RESET] to restart the job setting.
7.
Change the print quantity, as required.
Proof copy can be performed as needed, until the print quantity amount on
the Basic Screen reaches zero. (Note that the print quantity amount on the
Check Screen does not change.)
If required, change the print quantity on the Basic Screen.
8.
Press [START].
If the print quantity is not changed, the copier will output the rest, except the sample
sets.
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
3-52
DETAILS
image data will not be deleted from memory.
proof copying.
DETAILS
CAUTION