Copier Initial Setting; C Opier Initial Setting - Konica Minolta 7085 Instruction Manual

[2] Copier Initial Setting

Initial settings are the settings that display automatically when the copier is powered on,
when Auto/Reset timer is operated, or when [AUTO RESET] key is pressed. These
settings can be changed by the Key Operator, as shown in this section.
Initially (i.e., at installation), the Basic Screen displays the following conditions to meet
Energy Star requirements:
Initial Setting
Copy Mode
Copy Density
Lens Mode
Paper Tray
Output Mode
When Initial settings are changed by the Key Operator, the new initial settings display
when the copier is powered on, when Auto/Reset timer is reached, or when [AUTO
RESET] key is pressed.
The following initial settings can be changed by the Key Operator:
Copy mode
Copy density
Lens mode
Paper tray
Output mode
Special original :
Rotation
Setting procedures are described on the following pages.
NOTE:
The most commonly-used settings are established at installation. Before
changing any of the copier settings, be sure that you understand the overall
and long-range effect of the change.
Key Operator Mode Screen
13-10
: 1-1
: AE
: 1:1
: APS
: offset sort
: [RADF; 1-1; 1-2; 2-2; 2-1]
: [AE; manual]
: [AMS; ratio 0.25~4.00]
: [APS; trays 1, 2, 3, or LCT]
: [Non-sort; Sort, Group; Staple-sort; Stitch&Fold; Fold;
Punch; Trimming; Cover sheet]
[Original Direction; Text/Photo Enhance; Special Original;
Original Form]
: OFF
Copier Initial Setting Screen