Error Messages - Integra DTR-8.8 Instruction Manual

First Time Setup—Continued
7 After the 3rd or 7th measurement, the
following screen appears.
Auto Speaker Setup
Enter
Next
finish(Calculate)
Please select "Next", when measuring
next position, and select "finish",
Enter
when ending.
Use the Up and Down [
buttons to select an option, and
then press [Enter].
Next: Select this if you want to mea-
sure another listening posi-
tion. After the 8th
measurement has been taken,
the procedure automatically
proceeds to step 8.
Finish (Calculate): Select this if you
don't want to measure any
more listening positions and
are ready to calculate the
results, then go to step 8.
8 When the measurements are
complete, the following screen
appears.
Auto Speaker Setup
9
When the calculations are com-
plete, the following screen
appears.
Enter
Auto Speaker Setup
Save
Review SP Config
Review SP Distance
Review SP Level
Cancel
Enter
Use the Up and Down [
buttons to select an option, and
then press [Enter].
Save: Save the calculated settings
and exit the automatic
speaker setup.
Review SP Config: Review the
speaker configuration settings
(see "Reviewing the Results"
on page 59).
]/[ ]
Calculating...
]/[ ]
Review SP Distance: Review the
speaker distance settings (see
"Reviewing the Results" on
page 59).
Review SP Level: Review the speaker
level settings (see "Reviewing
the Results" on page 59).
Cancel: Cancel the automatic speaker
setup.
10
If you selected "Save," the results are
saved, and the following screen
appears.
Auto Speaker Setup
11 Disconnect the setup micro-
phone.
Auto Speaker Setup
Please unplug microphone.
Note:
• When the automatic speaker setup is complete, the
Equalizer Settings (page 106) will be set to Audyssey.

Error Messages

During the automatic speaker setup, one of the following
error messages may appear:
❑ Ambient noise is too high
Auto Speaker Setup
Retry
Cancel
Ambient noise is too high.
This message appears if there's too much background
noise and the measurements cannot be performed prop-
erly. Remove the source of the noise and try again, or
cancel the automatic speaker setup.
Saving...
57