Rear Removals; Drive Unit Removal - Lexmark C925 Service Manual

5041-030

Rear removals

Drive Unit removal

1.
Remove the HVPS. See
2.
Remove the plastic drive unit cover.
3.
Disconnect the drive motor wiring harnesses from the engine board.
4.
Disconnect the harness from the printhead controller board.
5.
Remove the three screws (A) in the upper left corner of the drive unit.
6.
Remove the screw (B) on top of the drive unit.
4-60
Service Manual
"HVPS removal" on page 4-87.
A
Previous
Next
Go Back