Led Assembly Removal - Lexmark C925 Service Manual

LED assembly removal

1.
Remove the transfer belt. See
2.
Remove the top cover. See
3.
Remove the rear EMI shield. See
4.
Remove the toner cartidges and imaging units.
5.
Disconnect the affected LED's ribbon cable from the printhead controller board.
6.
Guide the printhead ribbon cable through the top of the print engine.
7.
Remove the head holder screw (A) securing the LED holder to the top frame.
Note: You will need to remove the top EMI sheild to access the screw if you are removing the magenta or
yellow LED assembly.
"Transfer belt CRU removal" on page
"Top cover removal" on page
"Rear EMI shield removal– Not a FRU" on page
4-31.
4-11.
4-82.
Repair information
5041-030
Previous
Next
Go Back
4-19