Flash Test; Input Tray Tests; Printer Setup; Defaults - Lexmark C925 Service Manual

5041-030

Flash Test

This test causes the file system to write and read data on the flash to test the flash.
Warning: This test destroys all data on the flash because the flash is reformatted at the end of the test.
1.
Select Flash Test from DEVICE TESTS From the Diagnostics menu, navigate to:
DEVICE TESTS > Flash Test
A Contents will be lost warning appears.
2.
To exit the test immediately and return to DEVICE TESTS, select No and touch Submit. To continue with
the test, select Yes and touch Submit.
When the test starts, a progress bar appears. The test cannot be stopped or canceled once it has begun.
3.
Once the test is complete, the power indicator turns on solid and a message appears indicating whether
the test passed or failed. Press Stop (

Input Tray Tests

This test determines if the printer can feed media from any of the paper input sources. Each of the installed
sources is available within the Input Tray Tests menu.
To run the Input TrayTest:
1.
From the Diagnostics menu, touch INPUT TRAY TESTS.
2.
Select the input source.
3.
Select either Single or Continuous.
Note: If Single is selected, no buttons are active while the input device is feeding. If Continuous is
selected, Stop (
4.
At the end of the test, the printer returns to the INPUT TRAY TESTS menu.

PRINTER SETUP

Defaults

This setting is used by the printer to determine whether US or non-US factory defaults should be selected. The
following printer settings have different US and non-US values:
Printer default values
Paper Sizes setting in the General Settings menu
Default Paper Size (paper feeding sources which do not have
hardware size sensing capabilities)
Default Envelope Size
(envelope feeding sources which do not have hardware size
sensing capability)
Fax media size
PCL Symbol Set
PPDS Code Page
Universal Units of Measure
Modification of the printer setting Defaults causes the NVRAM space to be restored to the printer's factory
settings.
3-20
Service Manual
X
) to return to DEVICE TESTS.
X
) can be pressed to cancel the test.
US value Non-US value
U.S. Metric
Letter A4
10 Envelope DL Envelope
Letter A4
PC-8 PC-850
437 850
Inches Millimeters
Previous
Next
Go Back