Change History - Lexmark C925 Service Manual

Change history

Revision date
2013/12/16
2013/07/01
2012/06/25
2012/01/10
2011/12/14
2011/12/01
2011/11/22
2011/10/04
2011/08/09
2011/08/03
2011/05/05
Updates
Removed the Reset color calibration topic from the Diagnostic information chapter.
Added Steps before starting the 9yy.xx service checks.
• Added "Safety feature notice" on page
• Updated and changed the Abnormal fuser temperature error service check to
OFF switch automatically switching to the Off position service check" on
page 2-59.
Added the units/mach for the transfer roll bushing and duplex carrying gear under
components 1" on page 7-7.
Added an installation note in the
• Added a note in the "Paper feed unit removal" on page
• Added the following removal procedures:
- "Main tray paper guide removal" on page
- "Multi-purpose feed tray paper guide removal" on page
• Updated the parts catalog art for
Updated the "Printhead controller board / engine board replacement" on page
• Changed PN 40X6424 with PN 40X5984 for the
on page 7-21.
• Added Change history section
• Added the navigation buttons
• Added the following menu items under
- "Reset Separator Roll and Pick Assembly Counter" on page 3-8
- "Fuser Speed" on page 3-9
- "Wipe All Settings" on page 3-12
- "USB PnP" on page 3-13
- "Automatically Display Error Screens" on page 3-13
• Changed all references to Wipe Disk to
page 3-12.
• Removed the following menu item definitions:
- * Color Adjustment
- * Color Adj State
- * Motor Calibration
Updated the following removal procedures under Chapter 4:Repair information
- "Duplex removal" on page 4-53
- "Paper feed unit removal" on page 4-58
Added the "Top EMI sheild removal" on page
2-1.
"Waste toner sensor removal" on page
4-95.
"Paperfeed" on page 7-18.
"Low voltage power supply (220V)"
"Configuration Menu" on page 3-7
"Erase all information on Disks" on
4-30.
5041-030
"ON /
"Duplex
4-88.
4-58.
4-97.
4-2.
xvii
Preface
Previous
Next
Go Back